Jun 1, Please note this site no longer supports IE6. MG Midget — Engine Out. It is not a straight swap, a little bit of cutting, but not so hard either I did eventually paint the scuttle by the way. As planned, valves all lapped and ground back into their seats and resprung. Fast forward to !
MG Midget Dashes
Pull the rest of the old carpeting and vinyl out, including on the transmission tunnel, again noting the placement and size of the vinyl scraps and the extra vinyl attached to the panels. So a little creative sheet metal bending was in order to stop the rubbing. USA specification cars built after may have extra heat insulation material under the carpets due to the catalytic converter system. Turn the seat right side up, and using pliers if necessary, pull out each of the clips that hold the webbing into the seat frame. Check the fit of the rear deck carpet and glue it into place. Built-in bluetooth, You can use this function to connect to a phone songs Slide off the screw covers on each end of the door pulls and unscrew the old pull.
‘Early’ Late Model Dash | Tempus Fugit Garage
Unscrew the door latch handle with a 3 Phillips Screwdriver, and using a 1 Phillips screwdriver, take out the two small screws holding in the latch plate. Where holes are needed in new panels for screws or rivets, place the old panel on top of the new panels and tap the awl firmly with a hammer to punch the pilot hole at each spot. Thanks to a well insulated garage and a torpedo heater we were warm enough. Then snap carpet into place. Profile cancel You must be logged in to post a comment.
‘Early’ Late Model Dash
Description: Wade Keene, wadekeene att. Tape down the edges of the seat backboard to conform to the frame all the way around, creating a nicely curved back. Using scissors, cut a slit just big enough to allow for the frame in the flaps on each side at the rear of the seat. Wrap the new heater core with new foam packing and place it in the box. Turn over edge when tacky and press smooth along the edge, starting at the middle.